Influence of combing cylinder needle row density on the quality of combed sliverIssuing time:2022-06-08 11:00 In order to improve the quality of the combing sliver, experiments were carried out on the influence of the tooth density of the cylinder teeth and their arrangement. The test scheme and results were introduced. , the CV value of combed sliver, neps, impurities and short staple rate were decreased by about 0.4%, 10%, 20%-30% and 0.5% respectively, and the investment was less and the effect was obvious.Combing brush Cylinder is the key component of combing machine for combing sliver, it is responsible for the task of combing the front end of each fiber and most of its length in the sliver, making the fibers straight and parallel, and removing short fibers, impurities and other fibers in the sliver. Therefore, the quality of the combed sliver and the combed yarn h 3 Analysis of the results 3.1 Through the above comparative tests, it is obvious that the effect of the modified scheme 2 is better, that is, after the cylinder tooth density is increased, the CV value of the combed sliver is 0.4 percentage points lower than before the modification; The knots and impurities were reduced by 10%, 20%-30% respectively compared with before the modification; the short staple content of the combed sliver was reduced by about 0.5 percentage points compared with that before the modification; the quality index of the combed sliver was ideal. 3.2 After increasing the arrangement density of the cylinder teeth, the combing effect of the comb teeth on the fibers in each clamp is significantly improved, the penetrating ability of the comb to the fibers is enhanced, the strength of the fibers being combed increases, and the effect on the fibers is improved. The effective carding, the ability to remove linters and knots is enhanced, thereby improving the straightness and separation of the fibers. 3.3 By changing the arrangement of the cylinder teeth, the cylinder can achieve strong carding without excessive damage to the fibers, which maximizes the ability of the cylinder to remove short staples, neps and |