Applying Tampico brushes on the comberIssuing time:2022-04-16 11:00 The brush used in the comber turned out to be yellow-brown. The yellow-brown is less elastic, brittle, and varies in size (the thickest diameter is close to 1 mm, and the thinner is 0.08 mm). Suzhou Yuedaer Textile Brush,combing brush,Circular brushes,industrial brush,strip brushes Suzhou Yuedaer Textile Brush,combing brush,Circular brushes,industrial brush,strip brushes 1.png The specification and model of the Tampico fiber brush is: the diameter of the brush is 115mm, and the brush is placed in the deep cylinder of 3.5mm. The diameter of the brush core is 58mm, the length is 312mm, and the diameter of the Tampico fiber is 0.3mm. When cutting Tampico fiber brushes, the amount of cutting should not be too large, and slowly deaf to the desired diameter. After cutting, use a fine iron wire to polish and polish it to get rid of its "blunt end". When placing the sisal brush, it should not be pressed down, it must be vertical, and it should be stored loosely. Suzhou Yuedaer Textile Brush,combing brush,Circular brushes,industrial brush,strip brushes At this stage, the commonly used Tampico fiber brush has a Tampico fiber diameter of 0.3mm, which is not ideal enough. It is better to be thinner, but it is better not to reduce the elasticity. |